|Dimensions||518 × 320 × 60 mm|
|Number of faces|
Red leds, optional blue, green or white
|Recommended use margin|
0ºC to 60ºC
|Maximum use margin|
-10ºC to 60ºC
100V to 240VAC 50/60Hz
The DC-22SRT display is a clock and thermometer of simple use, with time and factory calibration. The display shows the current hour and minute, as well as the temperature with 0.1ºC resolution. The device is configurable so that the display turns off and on the digits at the time determined by the user.
In this display it is possible to program, by means of parameters, one hour of switching on and one of switching off. In the programmed interval the display will remain on; outside this interval, the display will remain off. If the same time and minutes are switched on and off, the display will never turn off.
- GPS option: Allows you to collect the time of the standard GPS signal. Thus allowing better synchronization at standard time without the need to connect the equipment to the Ethernet network.
- Ethernet option: It allows the interconnection of the visualizers, as well as their synchronization through SNTP and an improved user interface allowing to modify the configuration and that allows to see the time, date and GPS signal (if there is this option) and temperature.
- RS-485 Option: Allows the displays to synchronize on time via this bus.
- Relay output option: Available on all devices with IP41 protection level. Trigger levels above or below the displayed value can be programmed for each relay, as well as delay time or hysteresis. (2 or 4 relays with 15 programmable alarms per relay).
- Color option B: Displays the time in blue digits.
- Color option G: Shows the time in green digits.
- Color option W: Shows the time in white digits.
Installation / assembly manual
To download these files you must be registered. You can register here