Dimensions | 440 × 720 × 60 mm |
---|---|
Data display | CO2 level, Hour, Humidity, Temperature |
Number of faces | 1 |
Reading distance | 50 meters |
Digit height | 100mm |
Digit brightness | 1000 lux |
Digit color | Red leds |
Protection level | IP41 |
Recommended use margin | 0ºC to 60ºC |
Maximum use margin | -10ºC to 60ºC |
Power supply | 100V to 240VAC 50/60Hz |
DC-41RTHOV2
The DC-41SRTHO display is a clock, thermometer, hygrometer and CO2 meter of simple use, with time and factory calibration. The display shows the current hour and minute, the temperature with 0.1ºC resolution, the humidity with 1% resolution and the CO2 concentration with 1ppm resolution. The device is configurable so that the display turns off and on the digits at the time determined by the user.
In this display it is possible to program, by means of parameters, one hour of switching on and one of switching off. In the programmed interval the display will remain on; outside this interval, the display will remain off. If the same time and minutes are switched on and off, the display will never turn off.
Additional information
Options
Options
- GPS Option: Allows you to collect the time of the standard GPS signal. Thus allowing better synchronization at standard time without the need to connect the equipment to the Ethernet network.
- Ethernet option: The device incorporates a web server that allows you to see the time, date, GPS signal level (if there is this option), temperature, humidity and CO2 concentration. Allows you to modify the display settings. And it allows synchronizing the viewer with an SNTP server or creating a network of viewers to synchronize with each other.
- Relay output option: Available on all devices with IP41 protection level. Trigger levels above or below the displayed value can be programmed for each relay, as well as delay time or hysteresis. (2 or 4 relays with 15 programmable alarms per relay).
- RS-485 Option: Allows the displays to synchronize on time via this bus.